Printer messages (continued)
Message
35 Res Save Off
Deficient Memory
37 Insufficient
Collation Area
37 Insufficient
Defrag Memory
Action
The printer lacks the memory needed to enable
Resource Save. This message usually indicates too
much memory is allocated for one or more of the
printer link buffers.
• Press
to disable Resource Save and continue
Go
printing.
• To enable Resource Save after you get this
message:
– Make sure the link buffer is set to Auto, and exit
the menus to activate the link buffer changes.
When
Ready
is displayed, enable Resource
Save from the Setup Menu.
– Install additional memory.
The printer memory (or optional disk, if installed)
does not have the space necessary to collate the
print job.
• Press
to print the portion of the job already
Go
stored and begin collating the rest of the job.
• Cancel the current job. Press
The Job Menu is displayed. Press
until
<Menu
Cancel Job
line of the operator panel display. Press
The printer cannot defragment flash memory
because the printer memory used to store undeleted
flash resources is too full.
Press
to clear the message.
Go
To avoid another
37 Insufficient Defrag Memory
error message:
• Delete fonts, macros, and other data in printer
memory.
• Install additional printer memory.
13
or
Menu>
<Menu
or
Menu>
appears on the second
Select
.
.