Rgs Sender Properties - HP Xw460c - ProLiant - Blade Workstation User Manual

Using Remote Graphics Software
Rgreceiver.Usb.IsEnabled=bool
If set to "1", remote USB will be enabled. If set to "0", all remote USB will be
disabled and no network bandwidth will be consumed for remote USB.
This property only applies to HP Blade Workstation Client.
Rgreceiver.Usb.ActiveSession=int
When the RGS Receiver is in Directory Mode or Enterprise Service Mode, the
Receiver can connect to one or more RGS Senders. This property will specify the RGS
Sender that remote USB will be connected to. To have all remote USB go to the first
sender, use value zero. To have all remote USB go to the second sender, use value
one, and so on. Remote USB can only go to one sender at a time. To change the
sender, all senders must be disconnected. Then, enter a new value and reconnect all
senders. The default value is zero - the first sender to be connected.
This property only applies to HP Blade Workstation Client.

RGS Sender Properties

All of the following properties are used by the RGS Sender, and can be set from the
command line or from the RGS Sender property configuration file (rgsenderconfig).
General Properties:
Rgsender.IsRdpLogoutDetected=bool
The methods provided by Microsoft to close a connection through Remote Desktop
Protocol (RDP) work quickly when the user disconnects from the RDP session. If the
user logs out of the RDP session, the RGS Sender will be unable to access the
desktop for about 60 seconds. If set to "1", the desktop will be available to the user
through RGS as soon as possible. The RGS Sender will monitor the RDP session for a
logout and begin the process of making the desktop available as soon as the logout
is detected. If set to "0", the RGS Sender will not monitor the RDP session for a
logout.
This property only applies to Windows versions of the RGS Sender.
Rgsender.IsCopyRegionEnabled=bool
If set to "1", RGS Copy Regions are sent from the Sender to the Receiver. If set to
"0", RGS Copy Regions are turned off and will be sent to the Receiver as Image
Update Regions. This is for advanced use and should not be set. The default value is
"1" - send RGS Copy Regions.
Rgsender.IsRegionLimitEnabled=bool
Used to limit the number of update rectangles in a update region. This is for
advanced use and should not be set. The default value is 0 - don't limit regions.
81