Installing The Usb Device; Removing And Replacing The Battery; Figure - HP st5742 - Streaming Client Troubleshooting Manual
Thin clients and streaming thin clients
Hide thumbs
Also See for st5742 - Streaming Client:
- Specifications (2 pages) ,
- Quick setup and getting started manual (56 pages) ,
- Hardware reference manual (43 pages)
Table of Contents
Advertisement
Installing the USB Device
Before beginning the replacement process, review
on page 7
for procedures you should follow before and after installing or replacing hardware.
▲
Insert the USB device into the USB port in the secure USB compartment. See the following
illustration for the location of the ports in the secure USB compartment.
Figure 2-7
Removing and Replacing the Battery
Before beginning the replacement process, review
on page 7
for procedures you should follow before and after installing or replacing hardware.
WARNING!
access panel, ensure that the thin client is turned off and the power cord is disconnected from the
electrical outlet.
To remove and replace the battery:
1.
Locate the battery on the system board.
USB ports in the secure USB compartment
You must remove the right side panel to access the battery. Before removing the side
General Hardware Installation Sequence
General Hardware Installation Sequence
Installing Thin Client Options
13
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the st5742 - Streaming Client and is the answer not in the manual?
Questions and answers