HP st5742 - Streaming Client Troubleshooting Manual page 24

WARNING!
removing the side access panel, ensure that the thin client is turned off and the power cord is
disconnected from the electrical outlet.
CAUTION:
cards. Before beginning these procedures, ensure that you are discharged of static electricity by
briefly touching a grounded metal object. When handling a memory module, be careful not to touch
any of the contacts. Doing so may damage the module.
To install the SO-DIMM:
1. Slide the serial number tab out of the way.
NOTE:
2. Remove the access plate:
a.
b.
3. Hold the SO-DIMM at about a 20–degree angle and insert the SO-DIMM into the socket.
NOTE:
with the tab on the memory socket.
16 Chapter 2 Hardware Changes
You must remove the left side panel to access the SO-DIMM compartment. Before
Static electricity can damage the electronic components of the computer or optional
Be sure not to lose this tab.
Remove the two screws securing the access plate to the chassis.
Lift the rear edge of the plate and pull the plate back and up off the chassis.
A memory module can be installed in only one way. Match the notch on the module