Installing A Second So-Dimm - HP st5742 - Streaming Client Troubleshooting Manual

Thin clients and streaming thin clients

Hide thumbs Also See for st5742 - Streaming Client:

Table of Contents

To install the secondary flash memory module:

Locate the secondary flash memory module socket on the system board.

Figure 2-9

Figure 2-10

Insert the flash memory module into the socket on the system board.

NOTE:

memory module with the retention post on the system board.

Press the module connectors firmly into the flash memory module socket, making sure that the

retention post on the system board comes up through the hole in the module.

Installing a Second SO-DIMM

Before beginning the replacement process, review

on page 7

for procedures you should follow before and after installing or replacing hardware.

Installing the Secondary Flash Memory Module – t5740/t5745 models

Installing the Secondary Flash Memory Module – st5742/st5747 models

A flash memory module can be installed in only one way. Line up the hole in the flash

General Hardware Installation Sequence

Installing Thin Client Options

Table of Contents

Show Quick Links

Table of Contents

St5747 T5740 T5745