Paper Material Selection - Kyocera KM-4850w Operation Manual

4. Paper Material Selection

If the Media key is pressed, the paper material to be used can be
selected from "Plain", "Vellum ", "Film", and "Custom ". If the paper
material is selected, fixing temperature and copy size will be
automatically adjusted.
If "Custom" is selected, paper material, fixing temperature, and copy
size that have been set by using "@ Custom media type
[Custom.pap.material]" of the default setting will be selected.
(Page 7-3)
If "2 Media Type [Paper working]" of the default setting is set to "ON",
the paper material installed in each paper source can be registered. If
the Paper Source key is pressed to select a paper source, the paper
material setting will be automatically changed. See "2 Media Type
[Paper working]" and "3 Media type setting [Paper material
adjustment]" of the default setting. (Page 7-1)
1
Press the Media key.
(Inch)
2
Press the or key to select the paper material to be
used.
Select the material from "Plain", "Vellum", "Film", and
"Custom".
(Inch)
(Metric)
3
Press the OK key.
(Metric)
CHAPTER 4 BASIC COPYING
4
Check that the selected paper material is displayed in the
message display.
When the paper material is changed, wait until the fixing
temperature is stabilized. Scanning of an original, however,
can be performed.
(Inch)
(Metric)
4-5