Dew Prevention Heater - Kyocera KM-4850w Operation Manual

Insert the leading edge of the paper roll under the transport
9
guide plate and put out the edge from the guide plate by
approximately 1/2" [10 mm] as shown in the illustration.
NOTE
• If the leading edge of paper roll is folded or broken, cut the edge
using a cutter or the like.
10
Grasp the paper roll insertion latches and close the paper roll
insertion cover securely.
IMPORTANT
• If the paper roll that has been set is slackened, grasp the flange and
wind the paper roll to remove the slack. If not, paper may be fed
obliquely.
Insert the roll unit securely into the main body of the
11
machine.
12
Close the front cover.
13
To align the leading edge of the paper roll, press the Paper
Cut key. The leading edge of the paper roll will be ejected
from the copy eject slot.
(Inch)
NOTE
• Paper is normally cut in length of 11" [279 mm]. If the temperature in
the machine is lower than 15˚C, however, vellum will be cut in length
of 31" [800 mm].

(3) Dew prevention heater

If the humidity is high (more than 70%RH) or drastic temperature
change occurs, turn on ( ) the dew prevention heater switch when
using the machine. Even if the main power switch is off(O), the dew
prevention heater switch can be on ( ).
IMPORTANT
• When using vellum or film, be sure to turn off(O)the dew prevention
heater switch. If not, paper may be wrinkled or curled.
CHAPTER 3 PREPARATIONS
(Metric)
3-7