Chapter 5 Functional Copying; Zoom Mode; Standard Zoom - Kyocera KM-4850w Operation Manual

CHAPTER 5 FUNCTIONAL COPYING

1. Zoom mode

The magnification ratio can be set by pressing the O or P key. The
magnification ratio can be set to from 25% to 400% in 1% or 0.1%
increments. The method for setting the magnification ratio is de-
scribed below.
(Inch)
NOTE
• To switch the increment of the magnification ratio between 1% and
0.1%, see "2 Zoom step [Zoom steps] of the default setting.
(Page 7-4)
• If "APS" has been set, when the magnification ratio is changed, the
paper size will be automatically changed.
• If the magnification ratio increment is set to 1%, the fractional portion
of the number will be dropped.
• The minimum cut length of paper is 11" [279 mm]. If reduction and
synchronized cut are set and the calculated paper length is less
than 11" [279 mm], paper will be cut in length of 11" [279 mm] and a
blank area will be added in the trailing edge of the paper.
• To make reducing copies, make the length registered in the "‹ Reduce
length Ldt. " on page 7-7 longer than the length of originals you use.

(1) Standard zoom

The magnification ratio to be used is directly selected for reduction or
enlargement.
For the magnification ratios that can be selected, see "
magnification ratios" on page 5-2.
1
Press the Preset R/E key.
(Inch)
(Metric)
List of
(Metric)
2
Ensure that "Standard zoom" is selected.
(Inch)
(Metric)
3
Press the OK key.
4
Press the or key to select the desired magnification
ratio.
(Inch)
(Metric)
5
Press the OK key.
The machine will return to the basic screen. The selected
magnification ratio will be displayed.
5-1