Cr_Fanspeed Command; Cr_Simplemode Command; Cr_Rcode Command; Cr_Rsens Command - Sanyo PLC-HP7000L Technical Specifications

PLC-HP7000L Expand Serial Command Functional Specifications
Acceptable
Response
%1
Unacceptable

9.10.35 CR_FANSPEED Command

Command "CR_FANSPEED" [CR]
Details Get selected Fan Control Speed mode.
Acceptable
Response
%1
Unacceptable

9.10.36 CR_SIMPLEMODE Command

Command "CR_SIMPLEMODE" [CR]
Details Get setting status of Simple mode.
Acceptable
Response
%1
Unacceptable

9.10.37 CR_RCODE Command

Command "CR_RCODE" [CR]
Details Get selected Remote Control Code
Acceptable
Response
%1
Unacceptable

9.10.38 CR_RSENS Command

Command "CR_RSENS" [CR]
Details Get selected location of infrared remote receiver of remote control
Acceptable
Response
%1
Unacceptable

9.10.39 CR_RTYPE Command

Command "CR_RTYPE" [CR]
Details Get status of supported Remote Control (IR/RF).
"000_%1" [CR]
"1Y"-------Filter Exchange time is over value of Filter Message.
"1N"--Filter Exchange time is not over value of Filter Message.
"Error Code" [CR]
"000_%1" [CR]
"MAX" ------------------------ Max mode is selected
"NOR" ------------------------ Normal mode is selected
"Error Code" [CR]
"000_%1" [CR]
"ON" ------------------------ Simple mode is ON
"OFF" ---------------------- Simple mode is OFF
"Error Code" [CR]
"000_%1" [CR]
"001" --------------------------- Code 1 is selected
"002" --------------------------- Code 2 is selected
"003" --------------------------- Code 3 is selected
"004" --------------------------- Code 4 is selected
"005" --------------------------- Code 5 is selected
"006" --------------------------- Code 6 is selected
"007" --------------------------- Code 7 is selected
"008" --------------------------- Code 8 is selected
"Error Code" [CR]
"000_%1" [CR]
"BOTH" --------Select both front and back receiver of projector
"TOP" --------- Select only top receiver of projector
"BACK" ------- Select only back receiver of projector
"Error Code" [CR]
87/94