Pc Adjust Control Command; Cf_Fsync Command; Cf_Tdots Command; Cf_Clpphase Command - Sanyo PLC-HP7000L Technical Specifications

PLC-HP7000L Expand Serial Command Functional Specifications
8.5

PC Adjust Control Command

8.5.1

CF_FSYNC Command

Command "CF_FSYNC_%1" [CR]
"0000-0031" ----------------- Directly specify setting value of Fine Sync
%1 "UP" --------------------------- Increment setting value of Fine Sync by 1
"DN" --------------------------- Decrement setting value of Fine Sync by 1
Set value of Fine Sync in PC signal (Available only in the normal Power ON
status)
Details
The value set by this command will not be stored in the projector's memory.
Therefore, when the power is turned to ALL OFF status, the value returns to the
original setting.
Acceptable
Response
Unacceptable
8.5.2

CF_TDOTS Command

Command "CF_TDOTS_%1" [CR]
"mmmm - nnnn" --------------- Directly specify setting value of Total Dots
"mmmm" indicates minimum value, which is current (Display area H + Position H) value
%1 "nnnn" indicates maximum value, which is less than 140 MHz in Dot Clocks
"UP" ------------------------- Increment setting value of Total Dots by 1
"DN" ------------------------- Decrement setting value of Total Dots by 1
Set value of Total Dots in PC signal (Available only in the normal Power ON
status)
Details
The value set by this command will not be stored in the projector's memory.
Therefore, when the power is turned to ALL OFF status, the value returns to the
original setting.
Acceptable
Response
Unacceptable
8.5.3

CF_CLPPHASE Command

Command "CF_CLPPHASE_%1" [CR]
"0000-0255" ----------- Directly specify setting value of Clamp Phase
%1 "UP" --------------------- Increment setting value of Clamp Phase by 1
"DN" --------------------- Decrement setting value of Clamp Phase by 1
Set value of Clamp Phase (Available only in the normal Power ON status)
Details The value set by this command will not be stored in the projector. Therefore, when
the power is turned to ALL OFF, the value returns to the original setting.
Acceptable
Response
Unacceptable
"000" [CR]
"101" [CR] --- When input is Video signal
--- When input is no signal
"000" [CR]
"101" [CR] --- When input is Video signal
--- When input is no signal
"000" [CR]
"101" [CR] --- When input is Video signal
--- When input is no signal
25/94