Lamp Command; Cf_Lamph Command; Cf_Lampmode Command - Sanyo PLC-HP7000L Technical Specifications

PLC-HP7000L Expand Serial Command Functional Specifications
8.8

Lamp Command

8.8.1

CF_LAMPH Command

Command "CF_LAMPH_%1" [CR]
%1 "RST"
Details Reset lamp running time (Available only in the normal Power ON status)
Acceptable
Response
Unacceptable
8.8.2

CF_LAMPMODE Command

Command "CF_LAMPMODE_%1" [CR]
"NORMAL" ------------------------ Set Lamp status to Normal mode
"ECO1" ------------------------------- Set Lamp status to Eco1 mode
%1
"ECO2" ------------------------------- Set Lamp status to Eco2 mode
"AUTO" ----------------------------- Set Lamp status to Auto mode
Select Lamp mode (Available only in the normal Power ON status)
Details The value set by this command is stored in EEPROM and the setting remains
effective after the power is turned to ALL OFF status.
Acceptable
Response
Unacceptable
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
39/94