Table of Contents
Advertisement
U
O
SING
Your new Winmodem was designed and
tested using a wide range of Windows
communications software. If you'd like to use
another package instead of RapidComm, this
section will provide you with some of the
information commonly required when installing
communications software.
NOTE!
Your Winmodem requires
the use of fully Windows-based
communications software.
Type of Modem
Most communications software programs will
ask you to specify the modem you are using.
Select a U.S. Robotics Sportster high
speed modem. If that selection is not listed,
select U.S. Robotics Courier™
C
THER
OMMUNICATIONS
S
V.Everything® or one of the other Courier
high speed modems.
D
KEY POINT :
Refer to the manual
that came with your software for its
installation instructions. The
software's installation program will ask
you questions about the modem you are
using.
Initialization String
For hardware flow control, a fixed serial port
rate and full result codes type:
AT&F1 and press ENTER.
If you must use software flow control, type:
AT&F2 and press ENTER.
OFTWARE
47
Advertisement
Table of Contents
Troubleshooting
