US Robotics 002605-00 Installation Manual page 15

Make a note of the COM port and then
click OK. You may need this information
when installing communications software.
4. Windows will now restart. Click Yes on
this screen to restart Windows.
W H I
INMODEM ARDWARE
5.
NSTALLATION
When Windows restarts, check to see if
the Winmodem is correctly installed. Click
Start and point to Settings. Click
Control Panel. You should see a new
Winmodem icon like the one pictured
below. Turn to the section entitled
'Software Installation and Testing" (page
21) to begin installing your RapidComm
communications software.
11