Upgrade To Bcm 4.0 Through Hard Disk Replacement - Nortel BCM 4.0 Upgrade Manual

38 Chapter 5 Hard disk upgrade

Upgrade to BCM 4.0 through hard disk replacement

Use the following procedure to upgrade a BCM1000 system running BCM 2.x software to
BCM 4.0 by replacing the system hard disk. The hard disk upgrade does not preserve customer
data, including core data. You must reprogram all customer data after a successful upgrade.
To upgrade to BCM 4.0 through a hard disk replacement
1 Perform a cold start of your BCM 2.x system.
2
Power off your BCM 2.x system.
3 Remove the current hard disk from your system (see the Installation and Maintenance Guide).
4 Install the new BCM 4.0 hard disk into your system (see the Installation and Maintenance
Guide).
5 Initialize the hard disk (see the Installation and Maintenance Guide).
6 Connect to your system with Element Manager.
Open a web browser and access the BCM 4.0 system web page. Download and install Element
Manager on the management computer. Use the default username and password, nnadmin and
PlsChgMe!, to access your BCM 4.0 system. The first time you connect to the system, you
must change your password before continuing (after you enter the new password, click the
Welcome link to activate the confirm password box). For more information on connecting to
your system with Element Manager, see the BCM 4.0 Installation Checklist and Quick Start
Guide.
7
In Element Manager press the Cold Reset Telephony Services button (Administration >
Utilities > Reset) to perform a cold start and remove the old data.
8
Configure your system with Element Manager or the Startup Profile (see the Installation
Checklist and Quick Start Guide).
9 Re-program any remaining customer data and settings as required.
N0060597 N0060597