Nortel BCM 4.0 Upgrade Manual page 30

30 Chapter 4 Upgrading to BCM 4.0 and SRG 1.5
8 Click Next when you are ready to proceed.
If you entered incorrect information, you receive a condition message. Click OK and check
your entry.
After you click the Next button, the Upgrade Wizard performs a system validation to ensure
that your system is ready to receive the upgrade. It also configures FTP access and sends the
pre-check files to the BCM system. The wizard provides indicators of the various activities it
performs to set up and run the verification tool.
If you receive any condition messages during the verification process, refer to
"Troubleshooting," on page 39
When the verification is complete:
• If the verification is unsuccessful, you receive a condition message describing what is
missing from your system. In this case, click OK on the dialog box, and then click Exit on
the wizard page. Correct the problem before attempting to repeat the upgrade.
• If the verification is successful, the page shown in
a snapshot of the system information.
Figure 5 Screen showing system information and Begin Upgrade box
N0060597 N0060597
for more details about the condition.
Figure 5 appears. This page shows you
Appendix A,