Panasonic AW-RP505 Operating Instructions Manual page 30

ON position, the settings of the selected camera
will be similarly changed.
Switch r back to the OFF position before chang-
ing one camera for another with the CONTROL
Switch @2 .
2) Adjust the cable compensation, genlock, and total
pedestal of the selected camera.
• Cable Compensation
Signal degradation due to cable length between the multi-
port hub and the pan/tilt head can be compensated for.
q If the cable length from the pan/tilt head to the multi-
port hub is longer than 300 meters, set the cable com-
pensation switch on the pan/tilt head to the ON posi-
tion. For details, refer to INSTALLATION OF PAN/TILT
HEAD at page 19 or the Operating Instructions for
Pan/tilt Head.
w Connect a waveform monitor or a vectorscope to the
video output connector on the control panel for the
corresponding the camera pan/tilt head number ([1] to
[5]), set the video output connector on the multiport
hub, set the mode switch to the BAR position, then
observe the color bar signals.
e Adjust the Y (luminance) signal level with the CABLE
COMP Y control for the corresponding camera pan/tilt
head number ([1] to [5]), then adjust the CABLE
COMP Y control then adjust the C (chrominance) sig-
nal level with CABLE COMP C control. Repeat this until
Set the CAM CONT
-28-
the video output of the multiport hub is adjusted as
shown in the figure below.
Note: Turning CABLE COMP Y control changes not
only the Y (luminance) signal level but also the
video signal levels as a whole.
CABLE COMP Y Control
Multiport Hub
AW-HB505
C A B L E C O M P
1 2
P O W E R
O F F O N
Y C Y C
CABLE COMP C Control
Waveform Monitor
Vector Scope
3 4 5
Y C Y C Y C
M u l t l P o r t H u b A W - H 8 5 0 5
Color Monitor
(75 termination)