Panasonic AW-RP505 Operating Instructions Manual page 14

#7 Focus Lever [FOCUS FAR/NEAR]
Used to adjust the focus of the lens that is connected
to the pan/tilt head selected with CONTROL Switch @2 2 .
Used to adjust the lens focus at varying speed
depending on the angle of the lever.
focused far when the lever is moved toward FAR, or
near when the lever is moved toward NEAR, provided
that FOCUS REVERSE Switch %2 is in the NOR posi-
tion. When FOCUS REVERSE Switch %2 is set to the
REV position, the lens focus operates in the opposite
direction. ZOOM/FOCUS EXCHANGE Switch %1 may
be used to exchange its function with ZOOM Lever #6 .
#8 Pan/tilt Lever [PAN/TILT, UP/DOWN/LEFT/RIGHT]
Used to control the pan/tilt operation of the pan/tilt
head selected with CONTROL Switch @2 2 . Controls the
head's pan/tilt operation at varying speed depending
on the angle of the lever. The pan/tilt head turns up
when the lever is moved toward UP, or down when it is
moved toward DOWN, provided that TILT REVERSE
Switch %3 is in the NOR position. The pan/tilt head
moves in the opposite direction if the TILT REVERSE
Switch %3 is in the REV position. The pan/tilt head
turns leftward when the lever is moved toward LEFT, or
rightward when it is moved toward RIGHT, provided
that PAN REVERSE Switch %4 is in the NOR position.
The pan/tilt head moves in the opposite direction if the
PAN REVERSE Switch %4 is in the REV position.
Note: TILT REVERSE Switch %3 and PAN REVERSE
Switch %4 may be used to reverse the operating
direction of the pan/tilt head, but be sure to set the
operating direction of the pan/tilt head with its
The lens is mounting direction selection switch during its
installation depending on whether the pan/tilt head
is mounted on the floor or is suspended. Unless
the mounting direction selection switch on the
pan/tilt head is properly set, the pan/tilt head will
pan or tilt in the opposite direction and the pan/tilt
head operation limiters will not be properly stored
in the memory. For details on the setting of this
switch, refer to
at page 19 or the Operating Instructions for the
Pan/tilt Head.
-12-
INSTALLATION OF PAN/TILT HEAD