5. Camera and Pan/tilt Head Presetting
1) Select a desired operating camera and pan/tilt head
with the CONTROL switch @2 .
2) Pick up a desired object with the camera using
PAN/TILT Lever #8 ZOOM Lever #6 and FOCUS Lever
#7 Select a white balance control mode using
AUTO/ATW ATW Switch o AUTO/ATW A Switch !0 or
AUTO/ATW B Switch !1 . To store iris data in the mem-
ory, set IRIS AUTO/MANU Switch @5 to the MANU posi-
tion and turn the iris control. When IRIS AUTO/MANU
Switch @5 is in the AUTO position, iris data will not be
stored in the memory.
3) Keep MEMORY Switch @7 depressed (MEMORY Switch
@7 lights and all the 10 buttons of PRESET Switch @8
flash), press any of the buttons [1] to [10] of PRESET
Switch @8 as desired to store the data in the memory.
Only that button of PRESET Switch @8 where the data is
stored lights.
Note: If data is stored again in the same button of PRE-
SET Switch @8 the preceding data is deleted.
4) Repeat Steps 1) and 2) to store the presettings of all
thcameras an pan/tilt head in the memory.
6. Various Switch Settings
Select a desired operating camera and pan/tilt head with
the CONTROL switch @2 , then control the camera and
pan/tilt head using PRESET Switch @8 , PAN/TILT Lever #8 ,
ZOOM Lever #6 , FOCUS Lever #7 , IRIS AUTO/MANU
Switch @5 and other switches.
* In case of not changing the adjustment data and set-
tings, it is not necessary to repeat the adjustment and
setting procedures described in Sections 2 to 6.
-33-