Installation Of Pan/Tilt Head - Panasonic AW-RP505 Operating Instructions Manual

INSTALLATION OF PAN/TILT HEAD

• Install the pan/tilt head after carefully reading the
Operating Instructions for Pan/tilt Head.
• Have four hex bolts (M6 x 4) ready for mounting the
pan/title head. Select bolts of a length appropriate to
the material and structure of the mounting base and
the overall weight applied to it.
securely with plain washers, spring washers, and hex
nuts. If the bolts are not securely tightened, the pan/tilt
head might fall to cause injuries or accidents. In case
of suspending the pan/tilt head, locally purchase a
wire rod strong enough to hold the pan/tilt head, cam-
era, and lenses, pass it through the wire hole opened
in a firm board, such as of the ceiling, for example,
and fasten it securely.
• The switches on the pan/tilt head have been preset
before shipment from the factory on the assumption
that the pan/tilt head would be suspended from the
ceiling. If the pan/tilt head is mounted on a board, for
example, be sure to shift the mounting direction
switches on the pan/tilt head.
pan/tilt directions will be reversed and pan/head oper-
ation limiter data cannot be properly stored in the
memory. For details on shifting these switches, refer to
the Operating Instructions for Pan/tilt Head.
Fasten the bolts
Unless this is done,
-19-
Have a strong enough wire rod head and fasten it
securely to a firm board, such as of the ceiling.
Hole for wire rod to
prevent the head
from falling