Panasonic AW-RP501 Operating Instructions Manual page 15

8-pin DIN connector
pin assignment
(as viewed from the
rear of the control panel)
Example of auxillary
control circuit
$3 VIDEO InputT Connector
[TO CAMERA PAN/TILT HEAD, VIDEO IN]
(BNC Connector)
Connect it to the video output connector [VIDEO OUT]
on the pan/tilt head with a coaxial cable (5C-2V or
equivalent), which may be extended up to 500 meters.
$4 Genlock Output Connector
[TO CAMERA PAN/TILT HEAD, G/L OUT]
(BNC Connector)
Connect it to the G/L input connector [G/L IN] on the
pan/tilt head with a coaxial cable (5C-2V or equivalent)
in operating the camera in external sync mode. The
cable can be extended up to 500 meters.
Ground
6
7
8
3
1
5
4
Zoom
2
control
1 +5V
10K
100
2 ZOOM
100 10K
3 FOCUS
100
4 TILT
100
5 PAN
6 GND
SPEED switch
7 SPEED
8 IRIS
Note: Make sure that the lens and pan/tilt head stop
Ground GND
at the center point of the zoom, focus, pan and tilt controls
(or at the lever reset position if the controls have a lever reset function).
-13-
Focus Tilt Pan
control control control
6.8K
20K
10K
10K
6.8K
$5 Camera Control Output Connector
[TO CAMERA, PAN/TILT HEAD CAMERA CONTROL
OUT] (BNC Connector)
Connect it to camera control input connector [CAM-
ERA CONTROL IN] on the pan/tilt head with a coaxial
cable (5C-2V or equivalent), which may be extended
up to 500 meters.
$6 Pan/tilt Control Output Connector
[TO CAMERA PAN/TILT HEAD, PAN/TILT CONTROL
OUT] (RJ-45 8-pin Modular Jack)
Connect it to pan/tilt control output connector [P/T
CONTROL IN] on the pan/tilt head with a 10BASE-T
straight cable (UTP category 5 or equivalent), which
may be extended up to 500 meters.
Iris control