Rear Panel - Panasonic AW-RP501 Operating Instructions Manual

REAR PANEL

#9 TALLY Input Terminal [TALLY]
(2-pin Terminal Board)
Connect it to the tally connector on a special effect
generator (SEG) or a video switcher, for example.
When [HOT] terminal falls to ground level, TALLY
Indicator @2 and the tally indicator on the Pan/tilt Head
(AW-PH300) light red.
$0 12V DC Input Connector [DC 12V IN] (DC Jack)
Connect the AC Adaptor AW-PS301 (optional).
$1 1 Cord Clamp (Clamper)
Clamps the DC cord of the AC Adapter AW-PS301
(optional) connected to DC 12V IN Connector $0 to
prevent its disconnection.
G / L I N VIDEO OUT 1 VIDEO OUT 2
S - V I D E O O U T
T O C A M E R A P A N / T I L T H E A D
A U X C O N T R O L I N
P A N / T I L T C A M E R A
CONTROL OUT CONTROL OUT G/L OUT VIDEO IN
-12-
D C 1 2 V I N
T A L L Y
H O T
$2 Auxiliary Control Input Connector
[AUX CONTROL IN] (8-pin DIN Connector)
External control signals are input to this connector in
controlling the head's pan/tilt, lens zoom, focus and iris
operations.
Note: In externally controlling the pan/tilt head and
lens through this connector, set IRIS LEVEL
Control @6 on this control panel to the center point
(straight up), and do not simultaneously operate
SPEED Switch @9 , ZOOM Lever #6 , FOCUS Lever
#7 , and PAN/TILT Lever #8 . Operation errors may
occur if external controls are simultaneously used.