Panasonic AW-RP501 Operating Instructions Manual page 7

q Power Indicator [POWER]
Lights red when POWER ON/OFF Switch w is in the
ON position, and goes out when the same switch is set
to the OFF position.
w Power Control Switch [POWER, ON/OFF]
The camera and pan/tilt head are switched on when
this switch is set to the ON position. (The power indica-
tor lights.) The camera and pan/tilt head are partially
switched off when this switch is set to the OFF position.
Note: When the switch is set to the OFF position, the
camera is totally switched off but the communica-
tion line between the pan/tilt head and this control
panel remains live. To disconnect all power sup-
ply, pull out the power plug from the electrical out-
let.
e Operating Indicator [OPERATE]
Lights green when communication begins normally
between the camera and the control panel, and goes
out if a communication error occurs.
r Mode Selection Switch [MODE, BAR/CAM]
Used to select camera color bar signals or camera
video signals. With the switch set to BAR, the control
panel outputs color bar signals from the video output
terminal. When the switch is set to CAM, it outputs
camera video signals.
t AGC Selection Switch [GAIN, AGC/MANU]
Keep this switch in the AGC position if you want to
keep automatic gain control. When this switch is at
AGC, GAIN H/M/L Switch y is invalid.
y High Gain Selection Switch [GAIN, HIGH/MID/LOW]
This switch is valid only when GAIN AGC/MANU
Switch t is in the MANU position. Normally, keep it in
the LOW position. When the camera is used in a dark
place or when video output level is not high enough
even if the iris is wide open, set the switch to the MID
or HIGH position.
u Electronic Shutter Speed Selection Switch
[SHUTTER, ELC/ 1/100 /OFF]
Used to select a mode of camera electronic shutter
control. With the switch in the ELC position, the elec-
tronic shutter is controlled and the camera sensitivity is
automatically adjusted when using the camera in a
bright place. The shutter speed is 1/100 second when
the switch is in the 1/100 position. The electronic shut-
ter is off when the switch is in the OFF position.
i White Balance ATW Selection Switch
[AUTO/ATW, ATW]
When the switch is depressed, the camera keeps auto-
matically adjusting white balance. The switch lights
when it is selected.
-5-