Panasonic AW-RP501 Operating Instructions Manual page 8

o White Balance Ach Selection Switch
[AUTO/ATW, A]
When this switch is depressed, white balance will be
as stored in Channel A of the camera. The switch
lights when it is selected. When AWC Switch !1 is
pressed after selecting AUTO/ATW, A, white balance
is automatically adjusted and stored in Channel A.
!0 White Balance Bch Selection Switch
[AUTO/ATW, B]
When this switch is depressed, white balance will be
as stored in Channel B of the camera. The switch
lights when it is selected. When AWC Switch !1 is
pressed after selecting AUTO/ATW, B, white balance
is automatically adjusted and stored in Channel B.
!1 Auto White Start Switch [AWC]
If this switch is pressed when AUTO/ATW A Switch o
or AUTO/ATW B Switch !0 is selected, white balance is
automatically adjusted.
stored in Channel A or B. This switch is invalid if the
MODE BAR/CAM Switch r is in the BAR position.
Auto Set Indicator !3 flashes while AWC is in opera-
tion, and goes out when white balance has been prop-
erly adjusted. Auto Set Indicator !3 remains lit if white
balance adjustment fails.
Note: White balance may not be adjustable if there is
no white in the image being taken by the camera.
For details, refer to the Operating Instructions for
the Camera.
The adjustment results are
!2 Auto Black Start Switch [ABC]
When this switch is depressed, the lens iris is automat-
ically closed to set black balance. Be sure to keep the
IRIS AUTO/MANU Switch @5 in the AUTO position in
setting black balance. Auto Set Indicator !3 flashes
while ABC is in operation, and goes out when black
balance has been properly adjusted.
Indicator !3 remains lit if black balance adjustment
fails. Black balance adjustment may fail if the total
pedestal is too low. In such a case, adjust the total
pedestal with T.PED Control !9 (referring to the OPER-
ATING PROCEDURES at page 25) and try to adjust
black balance again.
!3 Auto Set Indicator
This LED flashes during white balance or black bal-
ance adjustment with AWC Switch !1 or ABC Switch !2
depressed, and goes out when the adjustment has
ended normally. The LED remains lit if balance adjust-
ment fails.
!4 Scene File Selection Switch [SCENE FILE, 1/2/3/4]
Select a scene file preset on the camera side.
Remember, however, that [4] is camera scene file
USER A or USER B (provided that WV-E550 or AW-
E560 is connected).
-6-
Auto Set