Tools Required; Installing A Hot Swap Hard Drive - HP Integrity rx4610 User Manual

Chapter 4: Installing Mass Storage Devices
4. PS
5. Other Boot Devices
IDE DVD drive
Flexible disk drive
6. PCI slot 1
7. PCI slot 2
8. PCI slot 3
9. PCI slot 4
10. PCI slot 5
11. PCI slot 6
12. PCI slot 7
13. PCI slot 8
14. PCI slot 9
15. PCI slot 10
The SCSI controller chip interfaces the PCI bus to two Ultra3 SCSI buses and contains an onboard
RISC processor. The RISC processor is a fully autonomous device, capable of managing multiple I/O
operations and associated data transfers from start to finish without host intervention. It provides
power management feature support in accordance with the PCI Bus Power Management Interface
Specification.
NOTE

Tools Required

The following tools are required for the removal and installation of mass storage devices in the HP
Server:
•
Phillips (cross-head) screwdriver (#2).
•
Small flat-bladed screwdriver.
•
Jumper-removal tool or needle-nosed pliers.
•
Antistatic wrist strap and conductive foam pad (recommended).
•
Pen or pencil.
•
Equipment log: to record the model and serial numbers of components.

Installing a Hot Swap Hard Drive

The HP Server supports a variety of single-ended SCSI SCA-type hard disk drives. The area of the
chassis below the system's controls and indicators on the front panel houses up to two 3.5-inch bays.
Each bay can contain a single industry-standard SCSI-2 or SCSI-3, one-inch high hard disk drive
The boot order can be changed using the Server's (BIOS) Setup Utility and the
Qlogic SCSI Utility. Refer to Chapter 10, "Configuring the HP Server" for more
information.
26