Appendix A: Specifications
Legacy I/O Board Jumpers
Jumper blocks exist on the Legacy I/O Board that allow you to perform recovery boot operations,
clear the CMOS register, clear the password, and configure FWH programming. To access these
jumper blocks you need remove the Legacy I/O Board by following the instructions in "Legacy I/O
Board" in Chapter 8.
Jumper labels:
J4A1 FWH Programming
J7A1 Recover Boot, CMOS Clear, and Password Clear
J7B1 Forced MBC Program Mode
J4A1
J7B1
Figure A-15. Legacy I/O Jumper Locations
J7A1
177