HP Integrity rx4610 User Manual page 68

Chapter 7: Installing Accessory Boards
Refer to Chapter 1, "Controls, Ports, and Indicators."
WARNING
2. Disconnect the power cables and any external cables connected to the HP Server. If necessary,
label each one to expedite re-assembly.
WARNING
3. Pull the chassis out of the rack.
CAUTION
4. Loosen the two thumbscrews in the back of the chassis that secure the rear cover.
Refer to Chapter 2, "Opening and Closing the HP Server."
5. Read the documentation included with the accessory board and follow any special instructions.
6. Identify the accessory slot number to be used. See Figure 7-3.
NOTE
The power supply will continue to provide standby current to the HP Server until
the power cable is disconnected.
Make sure that the rack is anchored securely, so it will not tip when the server
chassis is extended.
Wear a wrist-strap and use a static-dissipating work surface connected to the
chassis when handling components. Ensure the metal of the wrist-strap contacts
your skin.
PCI Hot Plug Slots
Figure 7-3. Accessory Slots
Refer to the Readme file for the Tested Products List that shows specific slot
recommendations for a particular PCI board type.
Non PCI Hot Plug Slots
61