Installing The Sideplane Board; Pci Hot Plug Led Board; Removing The Pci Hot Plug Led Board - HP Integrity rx4610 User Manual

Chapter 8: Server Management
7. Tilt the Sideplane up and out of the chassis.
8. Remove the two retaining screws from the Sideplane to remove the mounting plate.

Installing the Sideplane Board

To install the Sideplane board, complete the following steps:
1. Observe all safety and ESD precautions for handling electronic components.
2. Install the Sideplane on to the mounting plate by tightening the two mounting plate screws.
3. Lower the board into the side of the chassis, and slide it toward the rear of the chassis back into
position. The front lower corner of the board is the rotation point you should use when
positioning the board into place.
4. Tighten the captive thumbscrews on Sideplane to secure it to the chassis.
5. Reinstall the Power Distribution Board (T-Docking) as described in "Installing the Power
Distribution Board (T-Docking)".
6. Reinstall the I/O Baseboard as described in "Installing the I/O Baseboard".
7. Reinstall the Processor/Memory Complex as described in "Installing the Processor/Memory
Complex" in Chapter 5.

PCI Hot Plug LED Board

The PCI Hot Plug LED Board resides just on the inside of the top rear of the chassis. This board
enables PCI hot plug boards to be plugged into and out of the system without it being shut down.

Removing the PCI Hot Plug LED Board

To remove the PCI Hot Plug LED Board, complete the following procedure:
1. Observe all safety and ESD precautions for handling electronic components.
2. Turn off all peripheral devices connected to the system.
3. Power down the server by pressing and holding the Power button on the Front Control Panel.
You may have to hold the Power button down for several seconds. Removing the power cords
ensures that the server is not under standby power.
Figure 8-5. Remove the Sideplane
72