Installing A Cpu Thermal Dummy; Installing The Processor Baseboard - HP Integrity rx4610 User Manual

Chapter 6: Installing an Additional Processor

Installing a CPU Thermal Dummy

CPU thermal dummies must be installed where a processor is absent to properly direct cooling
airflow. Complete the following procedure to install a CPU thermal dummy:
Observe the safety and ESD precautions at the beginning of this chapter.
If you are installing a CPU thermal dummy, position the blank into place over the four posts on
the Processor Baseboard.
2. Secure the triple beam into place by tightening the captive screws on top of the beam and then
the four thumbscrews on the end of the beam.
3. Insert the sheet metal baffle located at the front of the processors or CPU thermal dummies in
the Processor/Memory Complex. To insert the baffle, press the flexible retaining tabs in as
you slide the baffle into place
4. Insert the Processor/Memory Complex into the chassis as described in Chapter 5, "Installing
the Processor/Memory Complex."

Installing the Processor Baseboard

The Processor Baseboard resides between the two halves of the Processor/Memory Complex.
Removal of the Processor Baseboard involves disassembly of the entire Processor/Memory Complex.
The board can accommodate one to four processors and two memory boards. If your server does not
have three or four processors, the underside of the Processor Baseboard will have CPU thermal
dummies in place of the processors and power pods. These assemblies are easily removed when you
lift the triple beam off the board.
Figure 6-5. Inserting a CPU Thermal Dummy
52