HP Integrity rx4610 User Manual page 12

Chapter 1: Controls, Ports, and Indicators
SCSI Hard Drives
The server supports up to two hot-swap drive carriers containing standard 1-inch high by 3.5-inch-
wide LVDS SCSI hard drives. As part of the hot-swap implementation, drive carriers with integral
heat sinks house the drives. Each drive is mounted in a carrier with four fasteners and the carrier
snaps into the hard drive bay. When a carrier is seated properly in the bay, it snaps into place and
leaves the locking handle exposed to the front of the chassis. Drives can consume up to 24 watts of
power and must be specified to run at a maximum ambient temperature of 40 ° C (104 ° F).
Power LED
Drive Active
Failure LED
Table 1-4. SCSI Drives
Control Indicator
Drive Power LED
(Green)
Drive Active LED
(Green)
Drive Fail LED
(Amber)
P O W E R R E S E T IN T
LC D D IS P LAY
P W R A C T IV E FA IL
P O W ER
Figure 1-4. SCSI Drive Indicators on the Front LED Panel
When lit continuously, it indicates the presence of
the drive and power to the drive.
When lit, it indicates drive activity.
When lit continuously, it indicates an asserted fault
status on one or more hard disk drives. When
flashing, it indicates a drive reset in progress.
S Y S P W R P W R FA N G E N
P W R A C T IV E FA IL
R E S ET I N T S Y S P W R P WR F AN G E N
L C D D ISP L AY
P WR A C TI V E F AI L P WR A C TI V E F AI L
Description
Failure LED
Drive Active
Power LED
5