Installing The 120 Mm Fans - HP Integrity rx4610 User Manual
Rx4610 user guide
Hide thumbs
Also See for Integrity rx4610:
- User manual (249 pages) ,
- Service manual (147 pages) ,
- Installation manual (16 pages)
Table of Contents
Advertisement
Chapter 3: Installing Fans and Power Supplies
Installing the 120 mm Fans
Follow these steps to install a 120 mm fan:
1. Slide the server out of the rack far enough to expose the fan-access door on the top of the
chassis.
2. Unscrew the thumbscrew on the front of the fan-access door and lift the door open.
3. Slide the new fan into place, with the connector oriented to engage the socket inside of the fan
enclosure.
4. Push the fan assembly firmly into the enclosure to seat the connector.
5. Close the fan-access door and tighten the thumbscrew.
6. Slide the chassis back into the rack.
Figure 3-2. Removing the 120 mm Fans
20
Advertisement
Table of Contents
