HP Integrity rx4610 User Manual page 137

Chapter 11: Troubleshooting
Table 11-1. BMC Beep Codes
Code
1-5-1-1
1-5-2-1
1-5-4-2
1-5-4-4
1-5-5-1
1-5-4-2
OR
1-5-4-4
300Ms
600Ms
Beep Code for 1-5-1-1 & 1 for Power Supply Configuration Failed to retain 3+1 redundancy
Description
FRB failure (processor failure)
No processors installed/detected
Power control fault. Power-good dropped out. This
beep code occurs during run time
PWRGD-BUF failure. System did not assert power-
good on power-up. Check installed D2D
configuration, verify processors seated, processor
power pods are connected, and Legacy cable
connector is secure with no bent pins. This beep
code ouccrs during system power on.
CPU board interlock failure. Verify CPU board
inserted fully.
1 Power Supply Configuration Failed to retain 3+1
redundancy (1 Redundant)
2-1 Processor1 Power Good failed due to power pod
failure or not connected to 48V
2-2 Processor2 Power Good failed due to power pod
failure or not connected to 48V
2-3 Processor3 Power Good failed due to power pod
failure or not connected to 48V
2-4 Processor4 Power Good failed due to power pod
failure or not connected to 48V
3-1 Upper Memory board power good failed.
3-1 Lower Memory board power good failed.
4 12V D2D Power Good failure.
5-1 I/O 5V A D2D Power Good failure.
5-2 I/O 5V B D2D Power Good failure.
6 PROC 3.3V D2D Power Good failure.
7-1 I/O 3.3V A D2D Power Good failure.
7-2 I/O 3.3V B D2D Power Good failure.
8-1 1.8V D2D Power Good failure (processor board
only).
300Ms
600Ms 600Ms
3Sec
130