Adapter Specifications - Cisco WAE-674-K9 - Wide Area Application Engine 674 Hardware Installation Manual

Adapter Specifications

Table 5-1 Inline Network Adapter LEDs
LEDs
Link / Activity
100
1000
Bypass
Note
Adapter Specifications
Table 5-2 Inline Network Adapter Specifications
Specification
Copper Gigabit Ethernet Specifications
IEEE standard
Full duplex and half duplex
Autonegotiation
Cisco Wide Area Application Engine 7341, 7371, and 674 Hardware Installation Guide
5-4
State Description
On The 10/100/1000BASE-T interface is receiving power.
Blinking The Ethernet link is transmitting data.
On The speed of the Ethernet connection is 100BASE-TX.
On The speed of the Ethernet connection is 1000BASE-TX.
Both the 100 and The corresponding ports are in mechanical bypass mode.
1000 LEDs are
on
On older inline network adapters, the LEDs are labelled 0, 1, 2, and 3. These
correspond to W1, L1, W0, and L0 respectively.
Table 5-2 describes the inline network adapter technical and general
specifications.
Description
Gigabit Ethernet, 1000BASE-T
Fast Ethernet, 100BASE-T
Ethernet, 10BASE-T
Supports both half-duplex and full-duplex operation in all
operating speeds
Autonegotiates between full-duplex and half-duplex
operations and between 1000-Mbps, 100-Mbps, and
10-Mbps speeds
Chapter 5 WAE Inline Network Adapter
OL-15012-02