Cisco WAE-674-K9 - Wide Area Application Engine 674 Hardware Installation Manual page 38

Installing the Wide Area Application Engine
1
When locked in position, an indicator (labeled 1 in
Note
side of the appliance. To remove the appliance from the rack, lift up on the lock
indicator and slide the appliance forward.
Lift the locking levers (labeled 1 in
Step 5
appliance into the rack until it extends approximately 4 inches (10.16 cm) from
the edge of the rack.
Figure 3-6
1
Attach the cable-management assembly to the rear of the slide rail using a hinge
Step 6
pin (labeled 1 in
assembly to the slide rail using a hinge pin.
Cisco Wide Area Application Engine 7341, 7371, and 674 Hardware Installation Guide
3-8
Lock indicator
Sliding in the WAE
Locking levers
Figure 3-7). Attach the free end of the cable-management
Chapter 3 Installing the Wide Area Application Engine
2 Slide Rail Hooks
Figure
Figure 3-6) on the slide rails and slide the
1
3-5) is visible on each
OL-15012-02