Remind Button; Using Light Path Diagnostics; Undetermined Problems - Cisco WAE-674-K9 - Wide Area Application Engine 674 Hardware Installation Manual

Chapter 6 Troubleshooting the System Hardware

Remind Button

Using Light Path Diagnostics

Undetermined Problems

Note
Note
OL-15012-02
You can use the Remind button on the Light Path Diagnostics panel to place the
front panel system error LED into the Remind mode. By pressing the button, you
acknowledge the failure but indicate that you will not take immediate action. If a
new failure occurs, the system error LED comes on again.
In the Remind mode, the system error LED flashes and remains in the Remind
mode until one of the following situations occurs:
All known problems are resolved.
•
• The system is restarted.
A new problem occurs.
•
You can use the Remind button to delay device maintenance until a later time.
Also, resetting the system error LED enables the LED to react to another error. If
the LED is still flashing from the first error, it masks additional errors.
The system error LED on the front of the device is on when certain system errors
occur. If the system error LED on your device is on, use
to help determine the cause of the error and the action needed. These actions
should only be performed by trained and qualified personnel.
Use the information in this section if the diagnostic tests did not identify the
failure, the devices list is incorrect, or the system is inoperative.
Damaged data in CMOS can cause undetermined problems.
Damaged data in BIOS code can cause undetermined problems.
Cisco Wide Area Application Engine 7341, 7371, and 674 Hardware Installation Guide

Undetermined Problems

Table 6-8 on page 6-30
6-21