Removing The Cover - Cisco WAE-674-K9 - Wide Area Application Engine 674 Hardware Installation Manual

Removing the Cover

Review the information in the
Step 1
"Safety Guidelines" section on page
Power off the device and all attached devices and disconnect all external cables
Step 2
and power cords.
Press down on the left and right side latches and pull the device out of the rack
Step 3
enclosure until both slide rails lock.
Note
Lift the cover-release latch (as shown in
Step 4
and set the cover aside.
Figure 4-1
Cisco Wide Area Application Engine 7341, 7371, and 674 Hardware Installation Guide
4-2
Chapter 4 Installing Hardware Options for the WAE-7371, WAE-7341, and WAE-674
You can reach the cables on the back of the device when the device is in
the locked position.
Removing the Cover
Cover-release latch
"Safety Warnings" section on page 2-1
2-4.
Figure 4-1). Lift the cover off the device
and the
OL-15012-02