Starting The Configuration/Setup Utility Program; Configuration/Setup Utility Menu Options - Cisco WAE-674-K9 - Wide Area Application Engine 674 Hardware Installation Manual

Starting the Configuration/Setup Utility Program

Starting the Configuration/Setup Utility Program
Step 1
Step 2
Step 3
Step 4

Configuration/Setup Utility Menu Options

Cisco Wide Area Application Engine 7341, 7371, and 674 Hardware Installation Guide
C-2
View and clear the error log
•
Enable USB keyboard and mouse support
•
To start the Configuration/Setup Utility program, follow these steps:
Turn on the device.
When the prompt Press F1 for Configuration/Setup appears, press F1.
If you have set both a user (power-on) password and a supervisor (administrator)
password, you must type the supervisor password to access the full
Configuration/Setup Utility menu. If you do not type the supervisor password, a
limited Configuration/Setup Utility menu is available.
Follow the instructions in the window.
Choose the settings to view or change.
The following choices are on the Configuration/Setup Utility main menu.
Depending on the version of your BIOS code, some menu choices might differ
slightly from these descriptions.
System Summary
Choose this option to view configuration information, including the type, speed,
and cache sizes of the microprocessors and the amount of installed memory. When
you make configuration changes through other options in the Configuration/Setup
Utility program, the changes are reflected in the system summary; you cannot
change settings directly in the system summary.
This option is on the full and limited Configuration/Setup Utility menu.
Appendix C Using the Configuration/Setup Utility Program
OL-15012-02