Machine Setup Options - Xerox 4118P - WorkCentre B/W Laser User Manual

Machine Setup Options

OPTION
Tray 1 Size
Tray 2 Size
Bypass Size
Collated
Power Save
Machine Time Out
Stamp RX Name
Xerox WorkCentre 4118 User Guide
SETTINGS
LTR / A4 / LGL / Folio
LTR / A4 / LGL / Folio
LTR / A4 / LGL / Folio /
A5 / Statement
On
Off
On
Off
15 / 30 / 60 / 180
Seconds
Off
On
Off
DESCRIPTION
Use to set the default paper size for Tray 1.
Paper Size options are Letter, A4, Legal (216 x
356 mm / 8.5 x 14 inch) or Folio.
Use to set the default paper size for Tray 2.
Paper Size options are Letter, A4, Legal (216 x
356 mm / 8.5 x 14 inch) or Folio.
Use to set the default paper size for the Bypass
Tray. Paper Size options are Letter, A4, Legal
(216 x 356 mm / 8.5 x 14 inch), Folio, A5 or
Statement.
If feeding media smaller than A4/Letter through
the bypass tray, the setting can remain set at
A4, Letter or Legal size.
When copying onto a paper size smaller than
A4/Letter, the printed image may be offset and
not reproduce correctly, even when Auto Fit is
selected.
Use to produce sets in the order 1,2,3 / 1,2,3 /
1,2,3.
Use to produce stacks in the order 1,1,1 / 2,2,2
/ 3,3,3.
Use to enable the Power Save feature. If On is
selected, set the period of time the machine
waits before Power Save is activated. Choose
between 15, 30, 60, 120 minutes.
Sets the number of seconds the machine
remains idle before the current job settings are
reset back to the default settings. Use Off to
deactivate the option.
Set to On to enable sender information, the
machine ID, the page number, the date and
time of reception and the reduction rate of the
image to be printed on each page of each
received transmission. The information is
printed on the bottom edge of each page.
Page 2-21