Error Message Appears On A Pictbridge Compliant Device - Canon 3300B002 On-Screen Manual

Error Message Appears on a PictBridge Compliant Device

>
Advanced Guide Troubleshooting
Error Message Appears on a PictBridge Compliant Device
The following are the possible errors that may occur when printing directly from a PictBridge compliant
device and the countermeasures to clear them.
Note
This section describes errors that are indicated on Canon-brand PictBridge compliant devices. The
error messages and operations may vary depending on the device you are using. For errors on non
-Canon PictBridge compliant devices, check the error message on the LCD and take the
appropriate action to clear the error. For details, see
For the errors indicated on the PictBridge compliant device and their solution, also refer to the
instruction manual of the device. For other troubles on the device, contact the manufacturer.
Error Message on the PictBridge
Compliant Device
"Printer in use"
"No paper"
"Paper Error"
"Paper jam"
"Printer cover open"
"No print head"
"Waste tank full"/"Ink absorber full"
"No ink"/"Ink cassette error"
"Hardware Error"
"Printer error"
> Error Message Appears on a PictBridge Compliant Device
An Error Message Is Displayed on the LCD
If the machine is printing from the computer or warming up,
wait until the job ends.
When it is ready, the machine starts printing automatically.
Load paper on the Rear Tray, and select Continue* in the
display on your PictBridge compliant device.
* To resume printing, you can also press the
the machine instead of selecting Continue on the device.
The Paper Output Tray is closed.
Open the Paper Output Tray, then press the
machine.
Select Stop in the display on your PictBridge compliant
device to stop printing.
Remove the jammed paper, load new paper, press the
button on the machine, and try printing again.
Close the Scanning Unit (Cover) on the machine.
The FINE Cartridge is not installed or the Cartridge may not
be compatible with this machine.
Check: See The following ink cartridge cannot be recognized.
in An Error Message Is Displayed on the LCD
appropriate action.
The ink absorber is nearly full.
Check: See The ink absorber is almost full.
Message Is Displayed on the LCD
action.
The FINE Cartridge has or may have run out of ink.
The FINE Cartridge may not be installed properly or may
not be compatible with this machine.
Check the error message on the LCD and take the
appropriate action to resolve the error.
An Error Message Is Displayed on the LCD
FINE Cartridge errors have occurred.
Replace the FINE Cartridge.
Routine Maintenance
An error requiring servicing may have occurred. (The Power
lamp flashes green and Alarm lamp flashes orange
alternately.)
Disconnect the USB cable between the machine and the
PictBridge compliant device, turn off the machine, and
unplug the power cord of the machine from the power
supply.
Plug the power cord of the machine back in, turn on the
Action
OK button on
OK
button on the
and take the
in An Error
and take the appropriate
Page 786 of 853 pages
.
OK