Cleaning The Paper Feed Roller - Canon 3300B002 On-Screen Manual

Cleaning the Paper Feed Roller

> Routine Maintenance
Contents
Cleaning the Paper Feed Roller
If the Paper Feed Roller is dirty or paper powder is attached to it, paper may not be fed properly.
In this case, clean the Paper Feed Roller. Cleaning will wear out the Paper Feed Roller, so perform this
only when necessary.
You need to prepare: three sheets of A4 or Letter-sized plain paper
1.
Make sure that the power is turned on, and remove any paper in the Rear Tray.
2.
Open the Paper Output Tray gently.
3.
Clean the Paper Feed Roller.
Press the Menu button.
(1)
Use the (Left) or
(2)
button.
The Settings screen will appear.
Use the (Left) or
(3)
button.
OK
The Maintenance screen will appear.
Use the (Up) or
(4)
button.
The confirmation screen will appear.
Use the (Up) or
(5)
The Paper Feed Roller will rotate as it is cleaned.
4.
Make sure that the Paper Feed Roller stops rotating, and load three sheets of A4 or
Letter-sized plain paper in the Rear Tray.
5.
Repeat the procedures of (4) to (5) in step 3, and clean the Paper Feed Roller with
the loaded papers in the Rear Tray.
The paper will be ejected after cleaning.
If this does not solve the problem, contact your service center.
> Cleaning the Paper Feed Roller
(Right) button to select Settings
(Right) button to select Maintenance
(Down) button to select Roller cleaning, and press the OK
(Down) button to select Yes, and press the
Advanced Guide Troubleshooting
, and press the OK
, and press the
button.
OK
Page 126 of 853 pages