Error Message Appears On A Pictbridge Compliant Device - Canon PIXM MX300 Series User Manual

Error Message Appears on a PictBridge Compliant Device

The following are the possible errors that may occur when printing directly from a PictBridge
compliant device and the countermeasures to clear them.
Note
This section describes errors that are indicated on Canon-brand PictBridge
compliant devices.
The error messages and operations may vary depending on the device you are using.
For errors on non-Canon PictBridge compliant devices, check the error message on
the LCD and take the appropriate action to clear the error. For details, see
Message Is Displayed on the
For the errors indicated on the PictBridge compliant device and their solution, also
refer to the instruction manual of the device. For other troubles on the device, contact
the manufacturer.
Error Message
On PictBridge
Compliant
Device
"Printer in use"
"No paper"
LCD.
If the machine is printing from the computer or
warming up, wait until the job ends. When it is
ready, the machine starts printing automatically.
When printing first after changing the media type,
the message asking you to confirm the position
of the paper thickness lever may appear on the
LCD on the machine. If this message is
displayed, make sure that the paper thickness
lever is set appropriate, then press the OK
button on the machine.
Load paper in the Rear Tray, and select
* in the display on your PictBridge
Continue
compliant device.
* To resume printing, you can also press the OK
button on the machine instead of selecting
Continue on the camera.
194
Action
An Error