Canon 3300B002 On-Screen Manual page 740

An Error Message Is Displayed on the LCD
The ink absorber is almost full.
Press OK to continue printing.
Contact the service center.
Printer error has occurred.
Contact the service center.
Timeout error has occurred.
Press OK.
Incompatible device detected.
Remove the device.
An unsupported USB hub is connected.
Remove the hub.
B200
Printer error has occurred.
Unplug the power cord and contact the
service center.
****
Printer error has occurred.
Turn off power then back on again.
If problem persists, see the manual.
Replace the empty ink cartridge immediately after the
printing. The resulting print quality is not satisfactory, if
printing is continued under the ink out condition.
Note
If the function for detecting the remaining ink level is
disabled, the ink cartridge in grey is displayed in the
remaining ink volume screen on the LCD.
Routine Maintenance
Since printing in this condition may cause the contents
of the fax to be lost, the machine stores received faxes
in memory without printing until the FINE Cartridge is
replaced. Print the fax stored in memory manually after
replacing the FINE Cartridge. You can set the machine
to print received faxes forcibly without storing them in
memory, but a part of contents or all contents of the fax
may not be printed.
The ink absorber is almost full.
Press the machine's OK button to continue printing. Contact
the service center.
The machine error has occurred.
Contact the service center.
Some errors occurred while copying and a certain time
passed.
OK
Press the button to dismiss the error, and try to copy
again.
Check the device connected to the Direct Print Port.
Printing photos directly is possible with a PictBridge
compliant device or the optional Bluetooth Unit BU-30.
A communication time out occurs if an operation takes
too long or if it takes too much time to send data. This
may cancel printing. In such cases, disconnect and
reconnect the USB cable.
When printing from a PictBridge compliant device,
depending on the model or brand of your device, you may
have to select a PictBridge compliant print mode on the
device before connecting it to the machine. You may also
have to turn on your device or select Play mode manually
after connecting the device to the machine. Perform
necessary operations before connecting your device
referring to its instruction manual.
If the error is still not resolved, check if you can print
another photograph.
If a PictBridge compliant device is connected via a USB hub,
remove the hub and connect it directly to the machine.
Turn off the machine, and unplug the power cord of the
machine from the power supply.
Contact the service center.
Important
If you disconnect the power plug, all the documents
stored in memory are deleted.
"****" is displayed in the alphanumeric character and
depends on the error occurred.
5100 is displayed:
Cancel printing, turn off the machine. Then clear the
jammed paper or protective material that is preventing
the FINE Cartridge Holder from moving, and turn on the
machine again.
Important
Page 740 of 853 pages