Oki MB451wMFP User Manual page 145

Error
Message
code
Please change File Name.
Please see Help for details.
to close
OK
Device communication protocol not
supported.
Please see Help for details.
to close
OK
Please check Network Share Name.
Please see Help for details.
to close
OK
Please remove the connected USB
device.
Unsupported USB device is
connected.
Please remove the USB Hub.
USB Hub is connected.
Access denied to PC.
Please check PC.
to Close
OK
Wireless startup failed.
Please see Help for details.
This wireless firmware version does
not operate on this device.
Please see Help for details.
Wireless settings are incomplete.
Please see Help for details.
Not connected to wireless access
point.
Please see Help for details.
<Status>
key
Blinks A file name was not authorized by the server.
 Change the file name.
 If using an FTP server to save data with Scan
to Network PC, there are some machines that
cannot be connected correctly due to
mismatching character codes. Change [Host
side Japanese Kanji code]. If using a Mac for
the FTP server, change [Host side Japanese
Kanji code] to [UTF-8].
Blinks The machine does not support the specified
server.
If using NAS to save data with Scan to Network
PC, in rare cases there are machines that cannot
connect correctly with CIFS. Change the profile
[CIFS Character Set] to [Shift-JIS] from
[UTF-16].
Blinks The name of a network shared folder is invalid.
 The machine failed to establish a CIFS
connection.
 Change the name of the shared folder.
Blinks Indicates that an unsupported USB device has
been connected.
This message will be displayed until the
unsupported USB device disconnected.
Blinks A USB hub has been connected. This machine
does not support the USB hub.
Disconnect the USB hub.
Lights up The PushScan request has been rejected by the
PC.
Blinks Wireless startup failed.
 Restart the device.
 If this does not solve the problem, contact your
dealer.
Blinks This wireless firmware version does not work on
this device.
 Contact your dealer.
Blinks Wireless is not operating because the settings
are incomplete.
 Try the manual settings or automatic settings
again.
 If this does not solve the problem, initialize the
network settings, and then try the manual
settings or automatic settings again.
Blinks Not connected to a wireless access point.
 Check that the wireless access point power is
switched on.
 Check the wireless access point settings, and
then try the manual settings or automatic
settings.
- 145 -
Error Messages
Cause/Remedy
7