Set Setup Snmp; Snmp Configuration Settings - HP AK241A - StorageWorks 8Gb Simple SAN Connection Cli Manual

set setup snmp

Description Configures SNMP on the switch.
Authority Admin session
Syntax
set setup snmp
Prompts you in a line-by-line fashion to change SNMP configuration settings.
SNMP configuration parameters. For each parameter, enter a new value or press Enter to accept the
current value shown in brackets.
Table 42

SNMP configuration settings

Parameter
SNMPEnabled
Contact
Location
Trap [1-5] Address
Trap [1-5] Port
Trap [1-5] Severity
Trap [1-5] Version
Trap [1-5] Enabled
ReadCommunity
WriteCommunity
TrapCommunity
Description
Enables (True) or disables (False) SNMP on the switch. The default is
True.
Specifies the name of the person to be contacted to respond to trap
events. The name can be up to 64 characters excluding #, semicolon (;),
and comma (,). The default is undefined. This value is also passed to the
Call Home service configuration.
Specifies the name of the switch location. The name can be up to 64
characters excluding #, semicolon (;), and comma (,). The default is
undefined. This value is also passed to the Call Home service
configuration.
Specifies the workstation IP address to which SNMP traps are sent. The
default address for trap 1 is 10.0.0.254. The default address for traps
2–5 is 0.0.0.0. Addresses, other than 0.0.0.0, for all traps must be
unique.
Specifies the workstation port to which SNMP traps are sent. Valid
workstation port numbers are 1–65535. The default is 162.
Specifies the severity level to use when monitoring trap events. The
default is Warning.
Specifies the SNMP version (1 or 2) to use in formatting traps. The
default is 2.
Specifies whether traps (event information) are enabled (True) or
disabled (False). The default is False.
Read community password that authorizes an SNMP agent to read
information from the switch. This is a write-only field. The value on the
switch and the SNMP management server must be the same. The read
community password can be up to 32 characters excluding #, semicolon
(;), and comma (,). The default is public.
Write community password that authorizes an SNMP agent to write
information to the switch. This is a write-only field. The value on the
switch and the SNMP management server must be the same. The write
community password can be up to 32 characters excluding #, semicolon
(;), and comma (,). The default is private.
Trap community password that authorizes an SNMP agent to receive
traps. This is a write-only field. The value on the switch and the SNMP
management server must be the same. The trap community password
can be up to 32 characters excluding #, semicolon (;), and comma (,).
The default is public.
8/20q Fibre Channel Switch command line interface guide 183
Table 42 describes the