HP AK241A - StorageWorks 8Gb Simple SAN Connection Cli Manual page 148

switch
Resets the switch without a power-on self test (POST). This is the default. This reset disrupts traffic
and does the following:
• Activates the pending firmware
• Closes all management sessions
• Clears the event log. To save the event log before resetting, see the
To reset the switch with a power-on self test, see the "hardreset" on page 132. To reset the switch
without disrupting traffic, see the "hotreset" on page 135.
NOTE:
• Firmware image files that have not been unpacked
• Configuration backup files
• Support files
system
Resets the system configuration settings to the factory default values as described in
NOTE:
communication with the switch. This operand does not affect installed license keys.
zoning
Clears the zoning database and deactivates the active zone set. The zoning configuration
parameters (MergeAutoSave, DefaultZone, DiscardInactive) remain unchanged. See
Table 18
Notes The following tables specify the various factory default settings:
• Enter the show setup callhome command to display the Call Home database configuration.
The default values are shown in
• Enter the show config switch command to display switch configuration. The default values
are shown in
Enter the show config port command to display port configuration. The default values are
•
shown in
• Enter show config threshold command to display port threshold alarm configuration. The
default values are shown in
• Enter the show config zoning command to display zoning configuration. The default values
are shown in
• Enter the show setup snmp command to display SNMP configuration. The default values are
shown in
• Enter the show setup radius command to display RADIUS configuration. The default values
are shown in
• Enter the show setup services command to display switch service configuration. The
default values are shown in
• Enter the show setup system command to display system configuration. The default values
are shown in
• Enter the show config security command to display security configuration. The default
values are shown in
148 Command reference
The following files are deleted from the switch during a switch reset:
Because this operand changes network parameters, the workstation could lose
for information about the zoning configuration parameters.
Table
Table 15.
Table 16.
Table
Table 18.
Table 19.
Table 20.
Table
Table 22.
Table 23.
14.
17.
21.
"set log" on page 171.
Table 22.