Set Setup Radius; Radius Service Attributes - HP AK241A - StorageWorks 8Gb Simple SAN Connection Cli Manual

set setup radius

Description Configures RADIUS servers on the switch.
Authority Admin session
Syntax
set setup radius
Prompts you in a line-by-line fashion to configure RADIUS servers for user account and device
authentication.
Table 40
Attribute
DeviceAuthOrder
UserAuthOrder
TotalServers
ServerIPAddress
ServerUDPPort
DeviceAuthServer
UserAuthServer
AccountingServer
Timeout
Retries
178 Command reference
Table 40 describes the RADIUS server configuration attributes.

RADIUS service attributes

Description
Authenticator priority for devices:
• Local: Authenticate devices using only the local security database.
This is the default.
• Radius: Authenticate devices using only the security database on the
RADIUS server.
• RadiusLocal: Authenticate devices using the RADIUS server security
database first. If the RADIUS server is unavailable, then use the local
switch security database.
Authenticator priority for user accounts:
• Local: Authenticate users using only the local security database. This
is the default.
• Radius: Authenticate users using only the security database on the
RADIUS server.
• RadiusLocal: Authenticate users using the RADIUS server security
database first. If the RADIUS server is unavailable, then use the local
switch security database.
Number of RADIUS servers to configure during this session. Setting
TotalServers to 0 disables all RADIUS authentication. The default is 0.
IP address of the RADIUS server. The default is 10.0.0.1.
User Datagram Protocol (UDP) port number on the RADIUS server. The
default is 1812.
Enable (True) or disable (False) this server for device authentication.
The default is False.
Enable (True) or disable (False) this server for user account
authentication. A user authentication RADIUS server requires a secure
management connection (SSL). The default is True.
Enable (True) or disable (False) this server for auditing of activity
during a user session. When enabled, user activity is audited whether
UserAuthServer is enabled or not.The default is False. The
accounting server UDP port number is the ServerUDPPort value plus 1
(the default is 1813).
Number of seconds to wait to receive a response from the RADIUS server
before timing out. The default is 2.
Number of retries after the first attempt to establish communication with
the RADIUS server fails. The default is 0.