Configuring The Ethernet Port; Verifying A Switch In The Network - HP AK241A - StorageWorks 8Gb Simple SAN Connection Cli Manual

The show setup system command displays the switch network configuration, as shown in the
following example:
8/20q FC Switch #> show setup system
System Information
------------------
EthNetworkEnable
EthNetworkDiscovery
EthNetworkAddress
EthNetworkMask
EthGatewayAddress
AdminTimeout
InactivityTimeout
LocalLogEnabled
RemoteLogEnabled
RemoteLogHostAddress
NTPClientEnabled
NTPServerAddress
EmbeddedGUIEnabled

Configuring the Ethernet port

Configure the switch Ethernet port using the set setup system command in an Admin session. The
following example configures a new IP address, subnet mask, and gateway address.
8/20q FC Switch (admin) #> set setup system
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
EthNetworkDiscovery
EthNetworkAddress
EthNetworkMask
EthGatewayAddress
10.20.30.254
AdminTimeout
InactivityTimeout
LocalLogEnabled
RemoteLogEnabled
RemoteLogHostAddress
NTPClientEnabled
NTPServerAddress
EmbeddedGUIEnabled
Do you want to save and activate this system setup? (y/n): [n] y

Verifying a switch in the network

You can use the ping command to verify that a switch is communicating in the network. The following
example successfully tests the network for a switch with IP address 10.20.1 1.57.
8/20q FC Switch #> ping 10.20.11.57
Ping command issued. Waiting for response...
8/20q FC Switch #>
Response successfully received from 10.20.11.57.
If the switch was unreachable, you would see the following display:
8/20q FC Switch #> ping 10.20.11.57
Ping command issued. Waiting for response...
No response from 10.20.11.57. Unreachable.
True
Static
10.20.11.32
255.255.252.0
10.20.8.254
30
0
True
False
10.0.0.254
True
51.68.85.102
True
(1=Static, 2=Bootp, 3=Dhcp, 4=Rarp)
(dot-notated IP Address)
(dot-notated IP Address)
(dot-notated IP Address)
(dec value 0-1440 minutes, 0=never)
(dec value 0-1440 minutes, 0=never)
(True / False)
(True / False)
(dot-notated IP Address)
(True / False)
(dot-notated IP Address)
(True / False)
8/20q Fibre Channel Switch command line interface guide
[Static ]
[10.0.0.1 ]10.20.30.40
[255.255.255.0] 255.0.0.0
[10.0.0.254 ]
[30 ]
[0 ]
[True ]
[False ]
[10.0.0.254 ]
[False ]
[10.0.0.254 ]
[True ]
27