Date - HP AK241A - StorageWorks 8Gb Simple SAN Connection Cli Manual

date

Description Displays or sets the system date and time. To set the date and time, the information string must be
provided in this format: MMDDhhmmCCYY. The new date and time takes effect immediately.
Authority Admin session except to display the date.
Syntax
date
[MMDDhhmmCCYY]
Operands
[MMDDhhmmCCYY]
Specifies the date by the day, month, time, and year–this requires an Admin session.
[MMDDhhmmCCYY] is as follows:
• MM—01 through 12 corresponds to January through December
• DD—01 through 31 corresponds to the day of the month
• hh—00 through 23 corresponds to the hour on a 24-hour clock
• mm—00 through 59 corresponds to the minute
• CC—20 corresponds to the millenium and century
• YY—00 through 99 corresponds to the decade and year
If you omit [MMDDhhmmCCYY], the current date is displayed, which does not require an Admin
session.
Notes Network Time Protocol (NTP) must be disabled to set the time with the date command. To disable
the NTPClientEnabled parameter, enter the set setup system command.
When setting the date and time on a switch that is enabled for SSL connections, the switch time must
be within 24 hours of the workstation time. Otherwise, the connection will fail.
Examples To display the date, enter the date command, as shown in the following example:
8/20q FC Switch #> date
Mon Apr 07 07:51:24 200x
To set the date and time (January 31, 10:15 AM, 2008), enter the date command, as shown in the
following example:
8/20q FC Switch #> admin start
8/20q FC Switch (admin) #> date 013110152008
8/20q FC Switch (admin) #> date
Thu Jan 31 10:15:03 UTC 2008
See also set setup system, page 185
8/20q Fibre Channel Switch command line interface guide 121