link-state-trap
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
link-state-trap
To enable an Simple Network Management Protocol (SNMP) link state trap on an interface, use the
link-state-trap command. To disable this feature, use the no form of the command.
Syntax Description
This command has no arguments or keywords.
Defaults
None.
Command Modes
Interface configuration submode.
Command History
Release
3.2(2c)
Usage Guidelines
None.
Examples
The following example enables the link-state-trap on the SME interface:
switch# config t
switch(config)# interface sme 4/1
switch(config-if)# link-state-trap
The following example disables the link-state-trap on the SME interface:
switch# config t
switch(config)# interface sme 4/1
switch(config-if)# no link-state-trap
Cisco MDS 9000 Family Storage Media Encryption Configuration Guide
A-20
link-state-trap
no link-state-trap
Modification
This command was introduced.
Appendix A
Cisco SME CLI Commands
OL-18091-01, Cisco MDS NX-OS Release 4.x