Setting Up The Cisco Sme Administrator And Recovery Officer Roles; Adding An Sme Interface From A Local Or Remote Switch - Cisco AJ732A - MDS 9134 Fabric Switch Configuration Manual

Chapter 7 Using the Command Line Interface to Configure SME
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Command
Step 2
switch(config)# sme cluster
clustername1
switch(config-sme-cl)#
Step 3
switch(config-sme-cl)# security-mode
basic
Setting Up the Cisco SME Administrator and Recovery Officer
Roles
To set up the Cisco SME Administrator, Cisco SME Storage Administrator, Cisco SME KMC
Administrator and Cisco SME Recovery Officer follow this step:
Command
Step 1
switch# setup sme

Adding an SME Interface from a Local or Remote Switch

Before adding an SME interface, be sure to enable clustering, enable Cisco SME, and start the Cisco
SME interface on the switch, and then add the interface to the cluster.
To add an SME interface from a local switch, follow these steps:
Command
Step 1
switch# config t
Step 2
switch(config)# sme cluster
clustername1
switch(config-sme-cl)#
Step 3
switch(config-sme-cl)# fabric
clustername1
Step 4
switch(config-sme-cl)# node local
switch(config-sme-cl-node)#
Step 5
switch(config-sme-cl-node)#
fabric-membership clustername1
Step 6
switch(config-sme-cl-node)#
interface sme 4/1 force
To add an SME interface from a remote switch, follow these steps:
Command
Step 1
switch# config t
Step 2
switch(config)# sme cluster
clustername1
switch(config-sme-cl)#
OL-18091-01, Cisco MDS NX-OS Release 4.x

Setting Up the Cisco SME Administrator and Recovery Officer Roles

Purpose
Specifies the cluster and enters SME cluster configuration
submode.
Sets the cluster security level to Basic.
Purpose
Sets up the four security roles.
Purpose
Enters configuration mode.
Specifies the cluster and enters SME cluster configuration
submode.
Specifies the fabric.
Enters the SME cluster node submode and specifies the
local switch.
Specifies the fabric membership for the cluster.
Adds the SME interface (4/1) from a local switch in fabric
f1.
Purpose
Enters configuration mode.
Specifies the cluster and enters SME cluster configuration
submode.
Cisco MDS 9000 Family Storage Media Encryption Configuration Guide
7-5