Cisco AJ732A - MDS 9134 Fabric Switch Configuration Manual page 195

Appendix A Cisco SME CLI Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
discover
To initiate the discovery of hosts, use the discovery command. To disable this feature, use the no form
of the command.
Syntax Description
host host port
target target port
vsan vsan id
fabric fabric name
Defaults
None.
Command Modes
Cisco SME cluster configuration submode.
Command History Release
3.2(2c)
Usage Guidelines
If the discover command is issued on an existing host that could be configured or discovered, then Cisco
SME deletes all the existing discovered LUNs, sends out a LOGO notification to the host, and does a
discovery again.
Examples
The following example discovers a host and specifies a target, a VSAN, and a fabric for discovery:
switch# config t
switch(config)# sme cluster clustername1
switch(config-sme-cl)# discover host 20:00:00:00:c9:49:28:47 target
21:01:00:e0:8b:29:7e:0c vsan 2345 fabric sw-xyz
The following example disables the discovery feature:
switch# config t
switch(config)# sme cluster clustername1
switch(config-sme-cl)# no discover
Related Commands Command
show sme cluster
OL-18091-01, Cisco MDS NX-OS Release 4.x
discover host host port target target port vsan vsan id fabric fabric name
no discover host host port target target port vsan vsan id fabric fabric name
Identifies the host port WWN. The format is hh:hh:hh:hh:hh:hh:hh:hh.
Identifies the target port WWN. The format is hh:hh:hh:hh:hh:hh:hh:hh.
Selects the VSAN identifier. The range is 1 to 4093.
Specifies the fabric for discovery. The maximum length is 32 characters.
Modification
This command was introduced.
Description
Displays information about the Cisco SME cluster.
Cisco MDS 9000 Family Storage Media Encryption Configuration Guide
discover
A-7